Pertech 5300 Manuel d'utilisateur télécharger pdf (Page 18)

Pertech Resources Inc. November 2005 220321A 12

11. Click “Finish”. Windows will issue a warning that the

driver is not digitally signed by Microsoft®. To install the

driver, click “Continue.”

Print Driver Setup

COMx Port Set up

If using RS-232, it is likely that rst time installers will

need to adjust the RS-232 parameters to match the

attached printer. After installing the driver, go to “Print-

ers and Faxes” on the “Start” menu and right click on

the 53xx printer driver. Select “Properties”. Select the

“Ports” tab. Select “Congure Port”. Verify that the baud

rate, parity data and stop bits and ow control match.

VERY IMPORTANT: Make sure that the Windows COM

port is set for Flow Control = Hardware (or XON/XOFF if

the attached printer is congured to for XON/XOFF). If

Flow Control is set to “None”, garbage print may eventu-

ally result. To check the printers conguration settings

see the next section of this manual “ Conguration &

Diagnostic Print Tests”.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Pas de commentaire

Pertech 5300 Manuel d'utilisateur Page 18