Pertech 5300 Manuel d'utilisateur télécharger pdf (Page 3)

Pertech Resources Inc. November 2005 220321A III

Important Information to the User

In order to ensure compliance with the Product Safety, FCC and CE marking requirements. you must use the power supply,

power cord, and interface cable which were shipped with this product or which meet the following parameters:

Power Supply

Input power to this product must be provided by one of the following:

(1) A NRTL Certied power source with a Limited Power Source

(LPS) output for use in North America, input rated 100 - 240 Vac, 1.5 A, 50/60 Hz, Output rated 24Vdc, 2.5 A Maximum and

60W Maximum. or

(2) A power source with a Limited Power Source (LPS) output Certied by an agency recognized in the country of

installation, input rated 100 - 240 Vac, 1.5 A, 50/60 Hz, Output rated 24Vdc, 2.5 A Maximum and 60W Maximum. Use of this

product with a power supply other than the Pertech power supply will require you to test this power supply and the Pertech

printer for FCC and CE mark certication.

Interface Cable

A shielded (360 degree) interface cable must be used with this product. The shield must be connected to the frame or earth

ground reference at each end of the cable.

Use of a cable other than the described here will require that you test this cable with the Pertech printer and your system

for FCC and CE mark certication.

Power cord

For North America a NRTL Recognized detachable power cord must be used. For applications where the power supply

module may be located on the oor, a power cord with Type SJT marking must be used.

For applications outside of North America, Power cords which meet the country of installation’s certication and application

requirements must be used.

Use of a power cord other than described here may result in a violation of safety certications which are in force in the

country of use.

1 2 3 4 5 6 7 8 ... 39 40

Pas de commentaire

Pertech 5300 Manuel d'utilisateur Page 3